The primary objective of this work was to characterize employee exposure to radon and progeny while performing guide/interpretation and concessions duties in a tourist cavern. Radon gas and progeny concentrations, fraction of unattached progeny, and other environmental parameters were evaluated in a popular tourist cavern in Southeastern New Mexico. Alpha-track detectors were used to measure radon gas in several cavern locations during a 9-mo period. Additionally, radon gas and attached and unattached fractions of radon progeny were measured at three primary cavern work locations during a 1-d period using a SARAD EQF 3220. Radon gas concentrations in the cavern were elevated due to extremely low air exchange rates with substantial seasonal variation. Mean measured radon concentrations ranged from 970 to 2,600 Bq m-3 in the main cavern and from 5,400 to 6,000 Bq m-3 in a smaller cave associated with the regional cave system. Measurements of unattached fractions (0.40-0.60) were higher than those commonly found in mines and other workplaces, leading to the potential for relatively high worker dose. Although radon gas concentrations were below the Occupational Safety and Health Administration Permissible Exposure Limit, employees working in the cavern have the potential to accrue ionizing radiation dose in excess of the annual effective dose limit recommended by the National Council on Radiation Protection and Measurements due to a high unattached fraction of radon progeny. There was a strong negative correlation between unattached fractions and equilibrium factors, but these parameters should be further evaluated for seasonal variation. Introduction of engineering controls such as ventilation could damage the cavern environment, so administrative controls, such as time management, are preferred to reduce employee dose.

BACKGROUND: Cannabis has been legalized in some form for much of the United States. The National Institute for Occupational Safety and Health (NIOSH) received a health hazard evaluation request from a Minnesota cannabis facility and their union to undertake an evaluation. METHODS: NIOSH representatives visited the facility in August 2016 and April 2017. Surface wipe samples were collected for analysis of delta-9 tetrahydrocannabinol (Delta9-THC), delta-9 tetrahydrocannabinol acid (Delta9-THCA), cannabidiol, and cannabinol. Environmental air samples were collected for volatile organic compounds (VOCs), endotoxins (limulus amebocyte lysate assay), and fungal diversity (NIOSH two-stage BC251 bioaerosol sampler with internal transcribed spacer region sequencing analysis). RESULTS: Surface wipe samples identified Delta9-THC throughout the facility. Diacetyl and 2,3-pentanedione were measured in initial VOC screening and subsequent sampling during tasks where heat transference was greatest, though levels were well below the NIOSH recommended exposure limits. Endotoxin concentrations were highest during processing activities, while internal transcribed spacer region sequencing revealed that the Basidiomycota genus, Wallemia, had the highest relative abundance. CONCLUSIONS: To the authors' knowledge, this is the first published report of potential diacetyl and 2,3-pentanedione exposure in the cannabis industry, most notably during cannabis decarboxylation. Endotoxin exposure was elevated during grinding, indicating that this is a potentially high-risk task. The findings indicate that potential health hazards of significance are present during cannabis processing, and employers should be aware of potential exposures to VOCs, endotoxin, and fungi. Further research into the degree of respiratory and dermal hazards and resulting health effects in this industry is recommended.